Druid 25LCD Energizer 5 Joules Shock for 2 zones

• Two 2.4 Joule independently monitored and controlled zones
• The robust and flexible design is ideal for residential, commercial, industrial and high-security sites
• Each zone can be set independently to be on/off or in high/low voltage modes
• Can be programmed into alarm sensor mode allowing it to be integrated into a separate burglar alarm system
• Four zones can easily be created by linking two Druid 25LCD energizers together using the Druid four-zone keypad
• Built-in alarm monitors tampering or faults on the high voltage and earth fence wires
• Connectable to armed response radio or GSM module
• Lightning and power surge protection
• Intelligent power saving to extend battery life
• Built-in gate alarm input to monitor if the gate is open or closed
• Optional keypad for controlling and programming the energizer. This allows the user to control the energizer remotely, with up to two keypads
• The relay expansion card can be used to increase the number of information outputs from the energizer
• Walk test mode for easy fence testing
• The LCD background colour changes to easily identify the fence condition

The Druid LCD energizer should ideally be operated by means of a remote keypad to
obtain access to the many energizer features and receive the greatest protection. It can
however be operated by means of a Nemtek tab or remote switch.
The energizer display will light with a blue (OFF), green (all is OK), yellow (alarm in history
or other medium priority event) or red (active alarm condition exists) background to
announce the energizer’s state at a glance and from a distance.
The gate input is functional even when the energizer is not energizing the fence. Use the
Gate Alarm Bypass function if this input is to be ignored.
The Druid LCD energizer includes many user and installer settings. These will be retained
in the event of total power loss. i.e. The battery is exhausted during a prolonged mains
failure.

A new battery with a full charge will typically provide in excess of 24 hours backup. This
time will vary with fence condition though.

The Druid LCD energizer incorporates an advanced and patented fence voltage regulation,
arc detection and avoidance system. What this means is that the fence energy is
maintained at a higher level than would normally be achievable using a conventional
energizer on the same fence, when factors such as poor or damaged insulators, wet
insulators after a rain storm, or salt build up on insulators (at the coast) prevent the fence
from supporting a high voltage. A conventional energizer will push all available energy
through any arcing that may occur across the insulator, thus reducing the fences
effectiveness. The Druid LCD energizer however will detect the arcing and then attempt to
operate the fence at a voltage just below that at which arcing occurs, thus maintaining
higher energy levels on the fence and improving the effectiveness of the fence. Nemtek is
the inventor and patent holder of this innovative technology.